Storm Damage Roofing in BelleviewOpen lots, open wind, honest scope.

Storm Damage Roofing in the downtown grid around Lake Lillian, Belleview Heights Estates, the US 441 and US 301 corridor, the Lake Weir side, Summerfield and the acreage and manufactured-home lots south and east of town.

Belleview sits on open former pasture and sand hill south of Ocala, and outside the oak canopy on the Lake Weir side there is little to slow wind before it reaches a roof edge. When Hurricane Milton crossed Florida on October 9 and 10, 2024, Marion County took tropical storm force gusts, and the Belleview calls that followed were eave and rake shingles lifted on the 1950s to 1980s block ranches around Lake Lillian and in Belleview Heights Estates, ridge caps with exposed fasteners pulled loose on the 1990s to 2010s homes along US 301 and toward Summerfield, and skylight and vent seals opened on manufactured homes on the acreage lots south and east of town.

Manufactured homes are the Belleview-specific storm problem. Metal and membrane roofs on double-wides lose their edge trim first, which lets wind get under the covering, and additions and porches built later leak at the roof-to-wall transition when the structure moves even slightly. After a storm we inspect those transitions and the marriage line specifically, because a tarp over the obvious opening does nothing for the seam that opened six feet away.

On a Belleview storm call the inspection starts at the ceiling, because on a low-slope block ranch the wet spot is rarely under the opening. We walk the attic or crawl the ceiling side first, then the roof, and we photograph the edge trim, the transitions on any addition, and the ridge before a single shingle is touched. Everything is dated in CompanyCam. From that we write a storm scope in the language your adjuster uses and a separate scope for whatever the roof already needed, with its own number, so a forty-year-old roof and a one-night storm are never mixed into one claim.

Brehm holds Florida certified roofing license CCC1336098 and general contractor license CRC1334991, carries general liability and workers' compensation, and is an Owens Corning Platinum Preferred Contractor. On a Belleview storm job that means fascia, decking and structural repairs happen on the same permit, and a replacement, if the damage justifies one, is installed to current Florida Building Code with the wind-mitigation photos your carrier wants. Belleview addresses are split between the City of Belleview and unincorporated Marion County, and the permit office depends on the parcel; we confirm it before anything is scheduled.

Here is how it actually went in Belleview after Milton: a lot of reset edge trim on manufactured homes, lifted eave shingles resealed on block ranches around Lake Lillian, a torn ridge cap or two toward Summerfield, and a tarp over a limb puncture on the Lake Weir side. Repairs, quoted as repairs. The roofs that were already done, we said so, because the carrier would have said so too. That is the answer you will get here, with the photos, before anything is filed.

Homes we work on in Belleview: 1950s to 1980s concrete block ranches on the downtown grid and in Belleview Heights Estates, manufactured and modular homes on acreage lots south and east of town, 1990s to 2010s homes along the US 441 and US 301 corridor and toward Summerfield, and lakefront homes on the Lake Weir side.